|
Trail Pro
Groom your Trails Faster with One machine, One Operator, and One Pass
Reist TrailPro: The 3-in-1 heavy-duty implement for municipal trail maintenance. The Reist TrailPro is a unique trail-grooming implement that trims edges, reclaims gravel and levels your trails in one pass.
- Reclaim & reuse trail material
- Angled blades removes high spots and level the trail
- Spinning rotor pulverizes and separates root balls and stone dust
- Carbide-tipped teeth spins at 540 RPM
- Leveling plate made from ¾” wear resistant steel
- Unique edging disc (one on each side) removes grass and weeds from side of trail
- Hydraulic top link is included
| TrailPro |
TP50 |
TP60 |
TP72 |
TP96 |
| Dimensions (WLH) |
55 x 66 x 34” |
67 x 66 x 34” |
79 x 66 x 34” |
103 x 66 x 34” |
| Working Width |
50” |
60” |
72” |
96” |
| Weight Ibs |
1,250 |
1,475 |
1,600 |
1,900 |
| Hitch |
CAT I |
CAT I |
CAT I |
CAT II |
USE OF TRAILPRO
POSITIONING: • Always use proper pin and bushing sizes when attaching TRAILPRO to tractor. • Ensure that the TRAILPRO’s cutting edge is parallel to the ground. If not, adjust the lift arms on the prime mover accordingly. • Stabilized 3 PTH arms to centre. • Check that when the TRAILPRO is sitting on a smooth surface, that there is 1/4” to 3/8” clearance between carbide tips of the Rotor to the floor surface. Rear Leveling Blade needs to be adjusted as cutting edges and leveling blade wear. • Lower TRAILPRO to ground, putting 3 PTH lever to max. down position. • Adjust top link until cutting blade makes ground contact by 1/8 inch. • With 3 PTH lever in max. down position start grading at 3 to 10 mph (5 to 15 km/h). • Readjust top link to maintain an average cutting depth of 1/8 inch.
STARTING THE TRAILPRO: • Be sure the area is clear of all bystanders • Refer to the prime mover starting instructions • Run the engine at low idle and slowly engage the PTO/hydraulic control • Increase the prime mover engine RPM to achieve the rated PTO speed.
STOPPING MACHINE: • Decrease engine speed to low idle • Disengaging PTO/hydraulic drive • Shut down the prime mover in accordance to instructions before getting off.
GROUND SPEED: • Travel speed is governed by the condition of the trails or surface being graded. Generally, the faster the better. Preferred speed is 5 to 15 km per hour. • The more grass on the trail the slower the speed. You might have to go down to a crawl when grading a trail for the first time. Especially if large amounts of sod is going through. • It is the responsibility of the operator to note the condition of the job being done and set the speed to obtain the proper grading effect and safety. |
